Intermec PF4I manual Setup Mode Serial Communication uart2 option

Chapter 7—Setup Mode

Setup Mode; Serial Communication "uart2:" (option)

(Intermec Fingerprint v8.20)

SETUP:SETUP: SER-COM, UART2

These menus will only be displayed when an optional Double Serial or Serial/Industrial interface board is installed. In case of a Double Serial interface baord, also see the overview for Serial Communication, uart3.

SER-COM, UART2:	SER-COM, UART2:	SER-COM, UART2:	SER-COM, UART2:	SER-COM, UART2:	SER-COM, UART2:
BAUDRATE	PROT ADDR	CHAR LENGTH	PARITY	STOP BITS	FLOWCONTROL
BAUDRATE;	PROT ADDR:	CHAR LENGTH	PARITY:	STOP BITS:	FLOW CONTROL:
	DISABLE	8	NONE	1	RTS/CTS
9600BAUDRATE;
	ENABLE	7	EVEN	2
19200BAUDRATE;
	Only displayed in case		ODD
38400BAUDRATE;					RTS/CTS:
			MARK
57500BAUDRATE;	of RS485.
			SPACE		DISABLE
115200BAUDRATE;
					ENABLE
300BAUDRATE;
600BAUDRATE;
1200BAUDRATE;
2400BAUDRATE;
4800

Menus inside this dotted box are not displayed in case of RS485 on "uart2:".

		SER-COM, UART2:	SER-COM, UART2:
		NEW LINE	REC BUF
FLOW CONTROL:	FLOW CONTROL:	NEW LINE:	REC BUF:
ENQ/ACK	XON/XOFF	CR/LF	[1024]:
		LF
ENQ-ACK:		CR
	XON/XOFF:	XON/XOFF:
DISABLE	DATA TO HOST	DATA FROM HOST
ENABLE
	DATA TO HOST:	DATA FROM HOST:
	DISABLE	DISABLE
	ENABLE	ENABLE

SER-COM, UART2:

TRANS BUF

TRANS BUF: [1024]:

SER-COM, UART2:

CONNECTED HW

CONNECTED HW:

RS232

Read-only

SER-COM, UART2:

PROTOCOL ADDR.

PROTOCOL ADDR. [1]:

Only displayed in case of RS485 on "uart2:". Enter printer’s protocol address (0–31).

Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint) 71