Intermec PF4I manual Media Supply Positions

Chapter 2—Installation

Media Supply Positions

There are four sets of slots and threaded holes in the printer’s center sec- tion for the media supply roll post or rotating hub (optional). These slots allow the largest possible roll size to fit, given the limitations of any liner takeup unit and/or the full enclosure provided by the long side door or Megatop. The positions are indicated by numbers engraved in the center section.

•Position 1 is used when the media compartment is fully enclosed by a long side door, regardless of the existence of any integral liner takeup unit. Maximum roll size is 152 mm (6 inches).

•Position 2 is not used.

•Position 3 is used when the printer has an integral liner takeup unit and a long side door. This position is also used with the 8-inch Megatop. Maximum roll size is 213 mm (8.38 inches).

•Position 4 is not used.

The printer can also use an external media supply located behind the printer, except when it has an 8-inch Megatop.

Position 3

Position 2 (not used)

Position 1

Position 4 (not used)

Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint) 11