Intermec PF4I manual Returning to Factory Default Setup, Factory Default? Enter=Yes ESC=No

Chapter 6—Setting Up the Printer

Returning to Factory Default Setup

There are two ways to return to the factory default setup of the printer:

AInsert a special CompactFlash memory card and restart the printer.

BUsing the printer’s built-in keyboard.

To reset the printer using the keyboard, do like this:

1Lift the printhead.

2Switch on the power to the printer and press the <i/F5> key and wait until the printer beeps.

3Swiftly press the following keys:

<d/F4> t <c/F2> t <c/F2> t <e/F1>

4The following message will be displayed:

Factory Default?

Enter=Yes ESC=No

5Within 10 seconds, press <Enter> to reset the printer to factory default. The parameters will be reset and the printer will continue the normal startup.

If you press <Esc/F2> or wait until the 10 seconds timeout has passed, the normal startup will continue without any reset being performed.

Note: If any of the files "card:NOSHELL.CFG", rom:NOSHELL.CFG", or "c:NOSHELL.CFG" exists in the printer’s memory, no reset to factory default will be performed.

The factory default will remove all files used to store settings. It will not reset settings that already has been read when the files are removed. This means that EasyLAN Wireless settings (SSID, keys, etc.) will retain their values from the previous start. However, the next reboot will reset them to factory default.

62 Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint)