Intermec PF4I manual Post Center section

Chapter 4—Media Load

Peel-Off, cont.

5 6

	Remove labels from the first 50 cm
	(20 inches) of the liner. Route the liner
	through the print mechanism, push it
	inwards, and adjust the edge guides so
Fit a new roll of labels on the supply	the label path becomes flush with the
post.	center section.
7	8

Close the edge guide on the supply post. Route the liner around the tear bar and the liner drive roller and back under the print mechanism and guide shaft.

Insert the start of the liner under the lip of the takeup hub, then rotate the hub counterclockwise a few turns to wind up some of the liner.

Intermec EasyCoder PF4i Compact Industrial—User’s Guide (Fingerprint) 35