Jabra GO 6470 user manual

The precise effect of each type of gesture depends on what you are currently doing (e.g., if you are already on a call, which phone is the current target, etc.). The table below summarizes all of the control possibilities presented by the multifunction button.

Function	Tap	Double-	Press	Long Press
		Tap	(hold 1-3 sec)	(hold 3-5 sec)
Answer incoming call	
Connect to the current target phone	
(e.g., go to dial tone; voice-activated dialing)
Enable voice-activated dialing (when target is	
a cell phone that supports this)
End current call (and activate held or incoming	
call, if any)
Call the last number dialed on current target		
phone (supported softphones and mobile
phones only)
Reject incoming call (when already on a call)		
Switch target phone (when no call is active)			
Power-on headset			
(when power is off)
Reject incoming call (when no call is active)			
Hold current call and switch to held or			
incoming call (supported softphones and
mobile phones only)
Power-off headset				
(when power is on)
Activate Bluetooth® pairing mode (when power				
is off)
Table 3: All multifunction button commands

The Touch Panel

The headset features a touch panel that is similar to the touch pad included with many laptop computers. Use it to adjust the volume you hear in your headset and to mute/unmute the microphone.

-Slide your finger up the touch panel (away from your mouth) to increase the volume.

-Slide your finger down the touch panel to decrease the volume.

-Double-tap on the touch panel to mute or unmute the microphone.

See also Section 6.6: Controlling the Speaker Volume and Microphone.

Jabra GO 6470 User manual

42