Jabra GO 6470 user manual System Setup and Connections, Setup Overview and Background

4. System Setup and Connections

This chapter explains how to assemble your Jabra GO solution and connect it to your other office equipment.

4.1Setup Overview and Background

Connection Diagram

Figure 5: Jabra GO base connections

Using a Headset with a Desk Phone

To accommodate the full range of desk phones in use, Jabra GO is able to adapt itself to your phone by offering the following settings:

-Termination standard

Though all desk phones use the same type of cable to connect the handset to the phone body, the internal wiring standard for this cable varies according to desk-phone model. Jabra GO supports all of the possible combinations and will assist you in finding the right one.

-Microphone level

The sound volume sent from your Jabra GO base must be adjusted to ensure that it is neither too quiet nor too loud for your desk-phone model.

-Electronic hookswitch or GN1000 Remote Handset Lifter

An electronic-hookswitch adapter or handset lifter will enable you to answer the phone or hang up using only the button on your headset or its docking operations. These are available as optional accessories for Jabra GO; the best choice for you will depend on your desk-phone model.

The Jabra GO setup wizard will help you to make each of the above settings.

Using a Headset with a Mobile Phone

To enable Bluetooth® wireless technology communication between your headset and mobile phone, you must pair the two units. The Jabra GO setup wizard will help you to do this.

Using a Headset with a Softphone

Softphone support is provided with Jabra GO 6470. To use Jabra GO 6470 with a softphone, you must connect the Jabra GO base to your PC via a USB cable and install the Jabra PC Suite collection of software and softphone drivers on your PC. The Jabra GO setup wizard will remind you to do this. You might need to install the actual softphone on your PC — if in doubt, please contact your IT administrator.

Jabra GO 6470 User manual

13