e_hd250.book Page 40 Tuesday, October 24, 2006 3:11 PM
PREPARATIONS FOR OPERATION
Loading/Unloading the Cassette
Cassette Loading
Use a videocassette tape marked MiniDV.
•To record, slide the switch on the back for use in prevent- ing accidental erasure to the “REC” side.
•Remove any the tape slack before loading.
1.Turn the POWER switch ON.
2.Slide the EJECT switch on the top panel of this device to the side.
The videocassette cover opens automatically and a vid- eocassette tape can be inserted.
3.Insert a videocassette tape into the videocassette holder. With the tape window facing out, move the switch on the back of the videocassette up and firmly push the center back of the videocassette straight in as far as it will go.
4.Carefully push the center (“Push here” sticker) of the vid- eocassette cover in the direction of the arrow as far as it will go to close it.
•After the cover is closed, it takes about 10 seconds until recording can begin or this device can enter STOP mode.
REC/SAVE | Tape window | |
switch | ||
|
EJECT switch
Cassette holder
Unloading the Cassette
1.Turn the POWER switch to ON.
2.When this device is in shooting standby mode or stop mode, slide the EJECT switch to the side and wait until the videocassette cover opens completely.
•The LED next to the EJECT switch flashes.
A few seconds pass before the videocassette tape is ejected.
3.The LED turns off and the videocassette cover opens.
•Take out the videocassette tape.
4.Carefully push the center of the videocassette cover in the direction of the arrow as far as it will go to close it.
CAUTION
•When you close the videocassette cover, push it in firmly as far as it will go. If the videocassette cover is not closed properly, it becomes
If this happens, firmly push the videocassette cover in again as far as it will go to lock it.
•The videocassette cover does not open during recording even if you slide the EJECT switch.
•Do not leave the videocassette cover open for a long time.
Dust or dirt may enter the inside and cause damage.
•Do not touch the videocassette cover or interfere with the eject operation while ejecting is in progress. This will cause damage.
•When you close the videocassette cover, do not press the black area of the inner cover.
Videocassette cover
Inner cover
If the power is on, the modes are as shown below.
MODE | REC/SAVE switch | ||
REC | SAVE | ||
| |||
Camera | STOP mode | ||
|
| REC INHIBIT is displayed | |
|
| on the LCD monitor and in | |
|
| the viewfinder. | |
|
|
| |
VTR | STOP mode |
| |
40
