JVC GY-HD251, GY-HD250 VIDEO FORMAT2/2 Menu Screen, Terminal, Y/P b/P r, R/G/B, Memo, Setting

e_hd250.book Page 79 Tuesday, October 24, 2006 3:11 PM

VIDEO FORMAT[2/2] Menu

Screen

* This is not displayed in VTR mode.

Item		Function/Setting (bold characters indicate initial settings)
PB TAPE	Selects whether to automatically detect the playback tape video format or play back only a particular format.
	Normally, use the “AUTO” setting.
	AUTO	: During tape playback, the format signal is switched automatically and played back.
	DV	: During tape playback, only the part of the tape recorded in DV format is played back.
	HDV	: During tape playback, only the part of the tape recorded in HDV format is played back.
	DVCAM	: During tape playback, only the part of the tape recorded in DVCAM format is played back.
	MEMO
	If you play back a tape containing both DV and HDV formats, the video signal is disturbed when the signal is
	switched.
HD/SD-SDI OUT	Sets whether or not to output SDI (Serial Digital Interface) signals from the HD/SD SDI OUT terminal.
	OFF	: No output.
	ON	: Output on. Embedded audio and time code are also output.
OUTPUT TERM. [DV]	Sets the output image format for the Y/PB/PR terminal in DV format.
	Y/Pb/Pr	: Outputs analog component signals.
	R/G/B	: Outputs analog RGB signals.
	Y/C	: Outputs YC separate signals.
	Signals are output from terminals as shown in the table below depending on the settings.

Terminal		Setting
	Y/Pb/Pr	R/G/B	Y/C
Y	Component Y	G	Y
PB	Component PB	B	C
PR	Component PR	R
(When the [PBPR/TC] switch is set to PBPR)
MEMO

•SYNC signals are added to all channels for RGB signals.

•In HDV format, signals are output in analog component format regardless of these settings.

SET UP	Selects whether to add a setup signal to the video signal output from the video signal output connector.
	In DV format, a setup signal can be added to COMPONENT output and Y/C output.
	(When Y/PB/PR or Y/C is set for OUTPUT TERM [DV])
	* You can also select a setup signal in the IEEE1394 signal input mode.
	0.0%	: No setup signal is added.
	7.5%	: A setup signal is added.
	Initial settings: U model: 7.5% E model: 0.0%

MEMO

•When recording composite video signals from an external device, set this item according to whether the input signals include a setup signal.

X See “Recording Composite Video Signals from an External Device” on page 65.

•When the FRAME RATE item is set to 50/25, this item is not displayed.

PAGE BACK When the cursor is in this position, press the SHUTTER dial to the VIDEO FORMAT[1/2] menu screen.

79