JVC GY-HD251, GY-HD250 manual Status, External Image Input Mode AUX IN, Contents, D V - 6 0 I A U

e_hd250.book Page 25 Tuesday, October 24, 2006 3:11 PM

External Image Input Mode (AUX IN)

	1	3	2
			4
8
a
			5
0	9 7		6 b
		STATUS 1 Screen

c 2

D V - 6 0 I A U X

4

5

76 b

STATUS 1 Screen

STATUS 1

In addition to the information on the STATUS 0 screen, this screen displays the following items.

No.	Item	Contents
1	VIDEO FORMAT display	Displays the currently selected video format.
		Allows you to select the REC item on the VIDEO FORMAT[1/2] menu screen. X See page 77.
		You can switch this display ON/OFF using the VIDEO FORMAT item on the LCD/VF[3/4] menu screen.
		X See page 91.

2Time Code (TC)/User’s Bits Indicates the time code (h:m:s:frame) or user’s bits data.

(UB) indication
	(Example) Time code	TC 00 : 00 : 00	:	00
					Colon (:) when non-drop frame mode
					Dot (.) when drop frame mode
	User’s bits	UB FF EE DD 20
	Whether or not to display this item is set with the TC/UB item on the LCD/VF[3/4] menu screen.
	X See page 91.
	Whether the time code or user’s bits should be shown is selected with the TC DISPLAY switch inside the
	LCD door.

3Synchronized display with an Lights up when the time code generator of this device synchronizes with the time code input from the TC

	external time code generator	IN terminal. Blinks when synchronization is unsuccessful. Turns off If there is no input signal.
4	Remaining tape indication	Remaining tape indication (displayed in 1-minute steps)
		This indicator blinks when remaining tape time is equivalent to less than 3 minutes.
		Whether or not to display this item is set with the TAPE REMAIN item on the LCD/VF[3/4] menu screen.
		X See page 91.
		* When inserting a brand-new tape, the remaining tape time is not indicated.
		When the tape has been run, the indication will appear.
		* The remaining tape indication is to be regarded only as a guide.
		* When this device is used at low temperatures, it may take a while before the indication of the remaining
		tape time appears.
5	Voltage indication	(Example) 12.2V: Indicates remaining battery level in 0.1V steps.
		Battery voltage and remaining battery are displayed. Select the display method in BATTERY INFO. on the
		LCD/VF[3/4] menu screen. X See page 91.
		Anton Bauer battery: Voltage/remaining capacity (%)/remaining time
		IDX Endura battery : Voltage/remaining capacity (%)

25