JVC VN-C655 manual Preparation Procedure, Set the camera in the following procedure

Preparation Procedure

Set the camera in the following procedure.

Step 1 Connection/Installation

Firstly, make a hole in the ceiling, followed by connecting the power cable, LAN cable or alarm signal cable to the terminal of the ceiling mount of this camera. Next, attach the camera to the ceiling. Do not forget to attach the safety wire.

Step 2 Network Settings

Install the software, set the network for this camera as well as using the "VN- C655U Setup Tool", and register the connected camera with the "V.Networks Controller".

☞Page 14

☞Page 23

●In a system where more than 1 VN-C655 is used, turn on the power for a VN-C655 first, followed by setting the camera until "2-3 Setting IP Address for this Camera Using the 'VN-C655U Setup Tool' " is completed. Upon doing so, turn on a second camera and perform setting in the same way. Perform the same procedure for

subsequent cameras. (☞Page 18)

Step 3 Setting Using the V.Networks Controller

Perform settings for Auto Pan, Auto Patrol, Auto Trace, Image Quality and Alarm	☞Page 54
using the "V. Networks Controller" software that has been installed.

Step 4 Operating Using the V.Networks Controller

The "V. Networks Controller" can also be used to perform recording/playback	☞Page 78
operations.

Step 5 Operating Using a Web Browser

Operation is possible via a web browser. ☞Page 85

13