Preparation (Step 1 Connection/Installation)

1-1 Connecting Cables (Continued)

This terminal is for connecting with an alarm annunciator such as an indicator, a lamp or a buzzer.

VN-C655

(Alarm Output Equivalent Circuit)

 

 

Alarm Device

 

 

Connection

 

 

Example

OUT

 

DC 12 V

Terminal

IN

R

Grounding

 

 

Terminal

 

 

 

GND

 

Output Requirements

¥Equivalent to NPN open collector output

(The output logic is set with [V.Networks Setup Tool.])

¥Allowed applied voltage: DC 12 V max.

¥Allowed input current: 50 mA

¥Momentary output: 1 to 5000 ms

(The duration is set with [V.Networks Setup Tool.])

Caution

Connect the VN-C655 grounding terminal to the one of the annunciator.

4. Connection of LAN Cables

Connect the camera to a hub or a PC by using a LAN cable.

¥ For hub connection Use a straight cable.

¥ For PC connection Use a cross-over cable.

Caution

There are a few types of LAN board for which a cross-over cable cannot be used. Check the specifications of the LAN board to be used before performing connection.

Note

When using 100 BASE-TX, ensure to use a Category 5 (or higher) cable.

16

Page 16
Image 16
JVC VN-C655 manual Preparation Connection/Installation, Connection of LAN Cables, Output Requirements