JVC VN-C655 manual Settings Network Settings

Settings (Step 2 Network Settings)

2-3 Setting IP Address for this Camera Using the "VN-C655U Setup Tool"

Set the IP address for VN-C655 using the "VN-C655U SetupTool" that has been installed. (This "VN-C655U Setup Tool" only allows connection of VN-C655.)

Caution

•Upon turning on the power of this camera, it may take about 60 seconds before it can be connected to the PC.

•At the factory, DHCP is enabled for VN-C655.

•Using DHCP

JVC does not recommend operating VN-C655 with the DHCP function enabled because a different IP address may be assigned upon the renewal of the leasing contract. The DHCP function of VN-C655 is included with the aim to simplify installation/setting procedures.

Note

•To connect to a VN-C655 for which DHCP has been enabled, the DHCP server must exist in an environment where the assigned IP address and MAC address are clearly defined. If the DHCP server is not found, it will automatically start up using the static IP address after 60 seconds.

1.Select [Start] †[Programs] †[V.NETWORKS] † [VN-C655U Setup Tool] to start up the "VN-C655U Setup Tool".

1 Enter the IP address of the camera to be connected in [Connection IP address]. Default IP address is 192.168.0.2.

2 Click .

Note

To view the IP address of the connected camera, click "Search".

The [V.Networks Search] screen is displayed.

Click to start search and a [V.Networks IP Address List] will appear.

•[TimeOut] is for setting the time for searching (1 to 30 seconds). If no IP address is displayed upon searching, change the value to a longer time and search again.

•If the [V.Networks] on the LAN has a different subnet from that of the PC, connection may not be possible even if the IP address of the camera is found via search. Change the IP address of the PC to an appropriate value and connect the camera.

28