Kentrox AI232 manual Diag-line

	AI232 Version 9.6x User’s Guide
	AI232 Commands: diag-line
Table 8-2 Line Monitor Mode Options (Continued)
Option	Function
interpret [ a x ]	Toggles the display of decoded packet data on the line
	monitor on or off and optionally selects the format of the data
	in the data portion of the packet (a or x).
	z a displays the data in the data portion of the packet in
	ASCII/hexadecimal format. Unprintable data
	(hexadecimal values 0x00 to 0x20 and 0x7F to 0xFF)
	appears as two digit hexadecimal numbers separated by
	a space. Printable data appears as printable characters.
	This option only applies to data.
	z x displays all the data in the data portion of the packet in
	hexadecimal format. All data appears as two-digit
	hexadecimal numbers separated by a space. This option
	only applies to data.
print	Prints the range of revealed LCNs for all lines.
CTRL+s	Pauses the line monitor.
go or CTRL+q	Reactivates the line monitor after displaying the line monitor
	options.
ESC or q	Quits monitoring traffic, exits from the line monitor, and
	returns to the prompt.
?	Displays a list of the options available for line monitoring
	diagnostics.

Tip: Press ENTER to execute a command and press ESC to end the diagnostic session.

CAUTION: If you are connected to AI232 through a serial port, do not monitor the port with command diag-line. Use command hide to hide and not monitor the port. Failure to comply with this statement can cause AI232 to become unresponsive.

Command Type

shell

Formats

diag-line

8-53