Kodak DCS600 manual Other symptoms, causes and remedies, Symptom Cause Remedy

Other symptoms, causes and remedies:

Symptom	Cause	Remedy
The camera settings cannot be	The camera is turned Off	Turn on the camera.
changed.
Autofocusing does not operate.	The Focus Mode selector is set to	Set the Focus Mode selector to C
	M.	or S.
The shutter does not release.	The camera is busy writing to the	Wait until the PC Card icon on the
	PC Card.	Back Status LCD panel stops
		blinking.
	The subject is not in focus.	Wait until the subject is in focus.
	No room on PC Card	Replace the PC Card or delete
		some images.
	No PC Card in camera	Insert a PC Card
The Frames Remaining indicator	The PC Card is full	Insert a different PC Card or delete
on the Back Status LCD panel		some images from the PC Card.
reads 0.
The battery icon on the Back	Battery is low	Recharge the battery, replace it
Status LCD panel shows that the		with a freshly charged battery, or
battery is low.		connect the AC adapter.
Exposed a burst of images and the	It takes time to save a burst of	Wait a few seconds.
Card icon continues to flash.	images.
The camera is “locked.” Nothing	The battery is not securely in place.	Remove then insert the battery.
works.
			Appendix
the camera is “locked.”	before changing batteries.	new battery. Wait 10 seconds,
The camera turned Off.	This can be caused by static	Turn the camera off then on, or
	electricity or a poorly loaded	remove the battery and install it
	battery.	again.
You just inserted a new battery and	You didn’t turn the camera Off	Turn off the camera. Remove the
		insert the same battery, then turn	B
		the camera On.
The Depth-of-Field Preview button	No PC Card is inserted.	Insert a PC Card.
does not work properly.

B-3