Kodak DCS600 Appendix B Troubleshooting, Top Status Viewfinder Shutter Cause and Remedy LCD Panel

Appendix B - Troubleshooting

If you run into a problem operating your camera, check the following table to see if you can find the cause of the problem. If the trouble persists, take the camera to your nearest dealer or service center.

Top Status		Viewfinder		Shutter	Cause and Remedy
LCD Panel
No indication	No indication			Locked	The battery is exhausted or improperly
					installed. Rotate the power switch to OFF and
					replace the battery.
FEE blinks	FEE blinks			Can be released	In Programmed Auto or Shutter-Priority Auto
					exposure mode, the lens is not set to the
					smallest aperture setting. Set the lens to the
					smallest aperture.
F--appears	F--appears			Can be released	With built-in CPU lens in Aperture-Priority
					Auto or Manual exposure mode, lens is not set
					to the smallest aperture setting. Set the lens to
					the smallest aperture with the Sub-Command
					Dial. Aperture can also be set by rotating the
					lens aperture ring. In this case, F--remains in
					the viewfinder and top LCD panel, and aperture	Appendix
					or Shutter-Priority Auto exposure mode cannot
					can only be confirmed through the aperture
					direct-readout in the viewfinder.
					Non-CPU lens is attached. Programmed Auto
					be selected. Set aperture by rotating lens	B
					aperture ring. In this case, aperture can only be
					confirmed through the aperture direct-readout
					in viewfinder.
Err and Alert LED	Err and Alert LED			Locked	Your camera has detected an abnormality in the
blink	blink				shutter diaphragm. Turn it off and on. If the
					same warnings continue to blink, take the
					camera to an authorized dealer or service
					center.
—			appears when	Can be released	3D Color Matrix Metering is set even though
		(•)
					attached lens has no CPU; camera
	3D Color Matrix
					automatically resets meter to Center-Weighted
	Metering is selected.
					Metering.

B-1