Cleaning the paper path | 1. Remove the wrapping from the Transport Cleaning Sheet. | |
| 2. Adjust the paper feeder guides to fit the cleaning sheet. | |
| 3. Feed the cleaning sheet (adhesive side up) through the scanner in | |
|
| portrait orientation until all residue is removed from the drive rollers. |
| 4. Adjust the feeder guides to fit, then feed the cleaning sheet | |
|
| (adhesive side up) through the scanner in landscape orientation |
|
| until all residue is removed from the drive rollers. |
| 5. Using the same cleaning sheet, repeat Steps 3 and 4, but feed the | |
|
| cleaning sheet through the scanner with the adhesive side down |
|
| until all residue is removed from the drive rollers. |
| NOTE: When a cleaning sheet gets very dirty, discard it and use a | |
|
| new one. |
Replacing parts | This section provides procedures for replacing the following parts. Use | |
| the list below as a guideline for frequency or replacement. Usage | |
| figures are not guaranteed. | |
| document type, the condition of documents being scanned, and not | |
| following the recommended cleaning and replacement procedures, can | |
| cause the life of the consumables to vary. | |
| • | Separator Module: 200,000 document pages |
| • | |
| • | Feed Module: 500,000 document pages |
| • | Imaging Guides: replace when guides are scratched or damaged |
NOTES:
•Kodak Scanners use replaceable tires than can feed a wide range of document types, sizes and thicknesses. Tire life and performance will vary based on the customer’s document set, the frequency of cleaning the transport and tires, and following the recommended schedule for changing tires. You should change the tires if you notice an increase in multiple feeds, stoppages, or a decrease in feeder performance that is not resolved by following the cleaning procedures.
•Certain paper types (such as carbonless paper or newsprint), failure to clean regularly, and/or use of
134 |
