Replacing Photo Conductor Unit (PCU)
Replacing Photo Conductor Unit (PCU)
When 'Replace photoconductor unit' appears on the panel display, it is time to replace the photo couductor unit.
RWARNING:
•Do not incinerate the photoconductor unit. Toner dust might ignite when exposed to an open flame. Dispose of the used photoconductor unit in accordance with local regulations for plastics.
Note
❒Do not tilt used PCU after removing it from the machine. If you do, toner might fall out.
❒Do not hold the developer cartridge when removing the used PCU from your machine. If you do, the cartridge might come unlocked and fall.
❒Do not touch the photo couductor. If you do, abnormal copies might be made.
❒ Before you remove the used PCU from the machine, wait until the machine | 5 |
has completely stopped and is making no sound. Failure to take this precaution could result in a fault.
❒If there are misfeeds, remove the misfed paper before removing the used PCU.
❒Be sure to remove the sealing tape before setting the new PCU. Leaving it on could cause a fault.
❒After replacing the PCU, the machine will take about 1 minutes to initialize. During this period, do not open the front cover or turn off the main switch. If you do, a fault might occur.
AIf the duplex unit is installed, open the duplex unit by pushing the catch upwards.
211