|
| Basics | |
|
| *4 | Place the paper in the bypass tray, and specify the paper size. ⇒ p.63 “When copying |
|
|
| onto custom size paper” |
|
|
| When paper larger than 433mm is used, there are cases when the paper will be |
|
|
| jammed, creased, or not fed. Make sure the paper is placed correctly so that it is fed |
|
| *5 | straight. |
|
| It is recommended to place one sheet at a time. | |
1 |
| ||
| *6 | The paper tray fence is fixed. If you wish to change the size of paper placed in this | |
|
|
| |
|
| *7 | tray, contact your service representative. |
|
| When loading paper, make sure that the stack height does not exceed the lower limit | |
|
| *8 | mark of the paper tray 2. ⇒ p.160 “Setting special paper in the Paper Tray 2” |
|
| When the paper size is larger than A4L, you can load 10 sheets. | |
|
| *9 | When the paper size is smaller than A4L, you can load 100 sheets. |
|
| When the thick paper size is larger than A4L, you can load 10 sheets.When the thick | |
|
| *10 | paper size is smaller than A4L, you can load 40 sheets. |
|
| When loading copy paper, make sure that the stack height does not exceed the limit | |
|
|
| mark. The maximum number of sheets you can load at a time depends on the paper |
|
|
| thickness and condition. |
|
| *11 | If you wish to copy onto thick (105g/m2, 28 lb or heavier) paper, select Thick Paper |
|
| *12 | mode. ⇒ "Special Paper Indication" in the System Settings manual |
|
| Paper size up to 600mm(23.6") is available when an optional HDD is installed. | |
Important
❒If you use damp or curled paper, staples may become jammed or a misfeed may occur.
Note
❒When loading copy paper in the paper tray
❒When loading copy paper in the bypass tray, place the copy side of the paper face down.
❒When you use the bypass tray, it is recommended to set the copy paper direc- tion to L.
❒Postcards and envelopes should be fed from the paper tray 2 or the bypass tray.
❒Some kinds of envelopes might cause misfeeds and wrinkles. In this case, push down the green lever of the fusing unit.⇒ p.65 “When copying onto envelopes”
❒Envelopes with large flaps should be fed from the paper tray 2 or a misfeed might occur. See the illustration below.
2
24