Copying from the Paper Tray 2
Copying from the Paper Tray 2
Use the paper tray 2 for copying onto special paper (OHP transparencies, label paper (adhesive labels), thick paper (for example postcards and en- velopes), thin paper) as well as plain paper.
You can also set special paper in the System Settings. ⇒ "Paper Size Set- ting" in the System Settings manual
Note
❒ If you do not use standard size copy paper, you should input vertical and horizontal dimensions. The sizes that you can input are as follows.
Metric | • Vertical: 100 – 297mm | |
version | • Horizontal: 148 – 432mm | |
|
|
|
Inch | • | Vertical: 4.0" – 11.7" |
version | • | Horizontal: 5.9" – 17.0" |
|
|
|
❒ For the paper size, type, and thickness you can use, or the maximum number of sheets you can load at a time, refer to “Copy Paper” ⇒ p.22.
❒ To make copies onto special paper (OHP transparencies, thick paper (for example postcards and enve- lopes), thin paper, label paper (ad- hesive labels)), you need to specify the paper type. ⇒ p.64 “When copying onto special paper”
❒ To load paper, refer to “Changing the Paper Size in Tray
ASelect tray 2, and then press the |
|
{#}key. | 2 |
Important
❒The paper size and type settings
programmed by pressing the {#}key are cleared and reset au- tomatically when copying is completed.
❒If the paper size displayed on the key for tray 2 is different from the paper set in tray 2, pa- per might be misfed. Make sure to remove paper in the tray after copying.
When copying onto standard size paper
This setting is necessary when temporarily copying onto a paper size which is not displayed on the size key of tray 2.
Note
❒This setting is not necessary if the size of paper displayed on the key for tray 2 and that of pa- per set in tray 2 are the same.
❒You can also specify the size of paper directly with the paper size selector for the paper tray 2.
57