Basics
| Turning On the Power |
1 | APress the operation switch. The |
On indicator goes on. |
The display panel will come on.
Note
❒If the power is not turned on when the operation switch is pressed, check if the main pow- er switch is on. If off, turn it on.
❒During the
AMake sure that the exposure glass c over or d oc umen t feed er is closed.
BPress the operation switch. The On indicator goes off.
Note
❒In the following cases, even if you press the operation switch, the indicator will not go off but blink:
•When the exposure glass cover or document feeder is open
•When communication is in
p r o g r e s s w i t h e x t e r n a l equipment
•When the hard disk is oper- ating
Turning Off the Main Power
AMake sure that the On indicator is off.
BTurn off the main power switch. The Main Power indicator goes off.
Important
❒Do not turn off the main power switch when the On indicator is lit or blinking. This might dam- age the hard disk or memory and cause malfunctions.
❒Pull out the power plug after you turn off the main power switch. If you do not, the hard disk or memory might be damaged. This could cause malfunctions.
❒Make sure 100% is displayed for the remaining memory space in facsimile mode before turning off the main power or unplug- ging the power cord. If the main power switch is turned off or the power cord is disconnected, any documents stored in fax
memory will be lost after ap- proximately one hour. ⇒Chap- ter 10, "When Power is Turned off or Fails" in Advanced Fea- tures manual of Fax Reference
16