15: Advanced Settings
Figure 15-5 CLI Configuration
2. Enter or modify the following settings:
|
| Table |
|
|
|
|
|
| Command Line Interface | Description |
|
| Configuration Settings |
|
|
| Login Password | Enter the password for Telnet access. |
|
|
|
|
|
| Enable Level Password | Enter the password for access to the Command Mode Enable level. |
|
|
| There is no password by default. |
|
| Quit Connect Line | Enter a string to terminate a connect line session and resume the |
|
|
| CLI. Type <control> before any key the user must press when |
|
|
| holding down the Ctrl key. An example of such a string is |
|
|
| <control>L. |
|
| Inactivity Timeout | Set an Inactivity Timeout value so the CLI session will disconnect if |
|
|
| no data is received after the designated time period. Default is 15 |
|
|
| minutes. Enter a value of 0 to disable. |
|
|
|
|
|
| Telnet State | Select Disabled to disable Telnet access. Telnet is enabled by |
|
|
| default. |
|
| Telnet Port | Enter the Telnet port to use for Telnet access. The default is 23. |
|
|
|
|
|
| Telnet Max Sessions | Maximum number of simultaneous Telnet sessions. The default is |
|
|
| 3 and the maximum is 10. |
|
| SSH State | Select Disabled to disable SSH access. SSH is enabled by default. |
|
|
|
|
|
| SSH Port | Enter the SSH port to use for SSH access. The default is 22. |
|
|
|
|
|
| SSH Max Sessions | Maximum number of simultaneous SSH sessions. The default is 3 |
|
|
| and the maximum is 10. |
|
|
|
|
|
|
|
|
|
EDS User Guide | 138 |
