|
| 9: Line and Tunnel Settings | |
|
|
|
|
| Tunnel - Accept Mode | Description |
|
| Settings (continued) |
|
|
| Flush Serial Data | Select Enabled to flush the serial data buffer on a new connection. |
|
|
|
|
|
| Block Serial Data | Select On to block, or not tunnel, serial data transmitted to the device. |
|
|
|
|
|
| Block Network | Select On to block, or not tunnel, network data transmitted to the device. |
|
|
|
|
|
| Password | Enter a password that clients must send to the device within 30 seconds from |
|
|
| opening a network connection to enable data transmission. |
|
|
| The password can have up to 31 characters and must contain only alphanumeric |
|
|
| characters and punctuation. When set, the password sent to the device must be |
|
|
| terminated with one of the following: (a) 0x0A (LF), (b) 0x00, (c) 0x0D 0x0A (CR |
|
|
| LF), or (d) 0x0D 0x00. |
|
|
|
|
|
| Email on Connect | Select whether the device sends an email when a connection is made. Select |
|
|
| None if you do not want to send an email. Otherwise, select the Email profile to |
|
|
| use for sending. |
|
|
|
|
|
| Email on Disconnect | Select whether the device sends an email when a connection is closed. Select |
|
|
| None if you do not want to send an email. Otherwise, select the Email profile to |
|
|
| use for sending. |
|
5.Click Submit.
6.Repeat above steps as desired, according to additional tunnel(s) available on your product.
EDS User Guide | 65 |
