Lantronix EDS4100 manual 12Tunnel Packing Mode, Tunnel Packing Mode Description Settings, Timeout

	9: Line and Tunnel Settings
	Table 9-12Tunnel Packing Mode
Tunnel - Packing Mode	Description
Settings
Mode	 Select Disable to disable Packing Mode completely.
	 Select Timeout to send data after the specified time has
	elapsed.
	 Select Send Character to send the queued data when the send
	character is received.
Threshold	Send the queued data when the number of queued bytes reaches
(Appears for both Timeout	the threshold. When the buffer fills to this specified amount of data
	in bytes (and the timeout has not elapsed), the device packs the
and Send Character
	data and sends it out; applies only if the Packing Mode is not
Modes)
	Disabled.
Timeout	Enter a time, in milliseconds, for the device to send the queued
(Appears for Timeout	data after the first character was received. Specifies the time
	duration in milliseconds; applies only if the Packing Mode is
Mode)
	Timeout.
Send Character	Enter the send character (single printable or control). Upon
(Appears for Send	receiving this character, the device sends out the queued data.
	The data is packed until the specified send character is
Character Mode)
	encountered. Similar to a start or stop character, the device packs
	the data until it sees the send character. The device then sends the
	packed data and the send character in the packet. Applies only if
	the Packing Mode is Send Character.
Trailing Character	Enter the trailing character (single printable or control). This
(Appears for Send	character is sent immediately following the send character. This is
	an optional setting. If a trailing character is defined, this character is
Character Mode)
	appended to data put on the network immediately following the
	send character.

5.Click Submit.

6.Repeat above steps as desired, according to additional tunnel(s) available on your product.

EDS User Guide 62