Lantronix EDS16PR, EDS32PR, EDS8PR Line Command Mode, To configure Command Mode on a specific line

9: Line and Tunnel Settings

Line Command Mode Figure 9-4 Line 1 Command Mode

Setting the Command Mode enables the CLI on the serial line.

To configure Command

Mode on a specific line:

1.Select Line on the menu bar, if you are not already in the Line web page.

2.Select a line number at the top of the page.

3.Select Command Mode. The Command Mode page for the selected line appears.

4. Enter or modify the following settings:

	Table 9-5Line Command Mode
Line – Command Mode	Description
Settings
Mode	Select the method of enabling Command Mode or choose to disable
	Command Mode.
	 Always = immediately enables Command Mode for the serial line.
	 Use Serial String = enables Command Mode when the serial string is
	read on the serial line during boot time.
	 Disabled = turns off Command Mode.
Wait Time	Enter the wait time for the serial string during boot-up in milliseconds.
Serial String	Enter the serial string characters. Select a string type.
	 Text = string of bytes that must be read on the Serial Line during boot
	time to enable Command Mode. It may contain a time element in x
	milliseconds, in the format {x}, to specify a required delay.
	 Binary = string of characters representing byte values where each
	hexadecimal byte value starts with \0x and each decimal byte value starts
	with \.
Echo Serial String	Select Yes to enable echoing of the serial string at boot-up.

EDS User Guide 55