Lexmark 675, 470, 35S5701, 670, MX510, MX410 manual Not enough free space in flash memory for resources

Troubleshooting 248

For non‑touch‑screen printer models, press and on the printer control panel simultaneously for 15 seconds to clear the message and continue printing.

If you do not wish to accept these risks, then remove the third-party supply or part from your printer, and then install a genuine Lexmark supply or part.

Note: For a list of supported supplies, see the “Ordering supplies” section of the User's Guide or visit www.lexmark.com.

Not enough free space in flash memory for resources [52]

Try one or more of the following:

•From the printer control panel, select Continue to clear the message and continue printing. For non‑touch‑screen

printer models, press to confirm.

•Delete fonts, macros, and other data stored in the flash memory.

•Upgrade to a larger capacity flash memory card.

Note: Downloaded fonts and macros that are not previously stored in the flash memory are deleted.

Printer had to restart. Last job may be incomplete.

From the printer control panel, touch to clear the message and continue printing. For non‑touch‑screen printer

models, press to confirm.

For more information, visit http://support.lexmark.com or contact customer support.

Reinstall missing or unresponsive cartridge [31.xy]

Try one or more of the following:

•Check if the toner cartridge is missing. If missing, install the toner cartridge.

For information on installing the cartridge, see the “Replacing supplies” section of the User’s Guide.

•If the toner cartridge is installed, then remove the unresponsive toner cartridge, and then reinstall it.

Note: If the message appears after reinstalling the supply, then the cartridge is defective. Replace the toner cartridge.

Reinstall missing or unresponsive imaging unit [31.xy]

Try one or more of the following:

•Check if the imaging unit is missing. If missing, install the imaging unit.

For information on installing the imaging unit, see the “Replacing supplies” section of the User’s Guide.

•If the imaging unit is installed, then remove the unresponsive imaging unit, and then reinstall it.

Note: If the message appears after reinstalling the supply, then the imaging unit is defective. Replace the imaging unit.