Lexmark 35S5701 Solving printer problems, Supply needed to complete job, Too many trays attached

Troubleshooting 253

Supply needed to complete job

Do either of the following:

•Install the missing supply to complete the job.

•Cancel the current job.

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:

•From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen

printer models, press to confirm.

•Format the flash memory.

Note: If the error message remains, then the flash memory may be defective and need to be replaced.

Weblink server not set up. Contact system administrator.

Select Continue to clear the message. For non‑touch‑screen printer models, press to confirm.

Note: If the message appears again, then contact your system support person.

Solving printer problems

•“Basic printer problems” on page 254

•“Hardware and internal option problems” on page 256

•“Paper feed problems” on page 258