After replacing the fuser or transfer belt, you must reset the maintenance counter.
If the message Did you replace Fuser? or Did you replace Belt? appears, press Go. Otherwise, use the following steps to reset the fuser or transfer belt counter.
Note: Although the fuser is shown, the same procedure is used to clear the transfer belt.
1Press Menu until Supplies Menu appears on the second line of the display.
SUPPLIES MENU
1 Menu 2 | Select 3 Return 4 |
Go 5 | Stop 6 |
2Press Select to open the Supplies Menu.
3Press Menu until Replace Supplies appears on the second line of the display.
SUPPLIES MENU
REPLACE SUPPLIES
1 Menu 2 | Select 3 Return 4 |
Go 5 | Stop 6 |
4 Press Select to open Replace Supplies.
