Lexmark C935 Creating an administrative password, Using Secure mode, 146, Click Create Password

To install and use certificates as part of the credentials:

1Open a Web browser. In the address bar, type the IP address of the printer or print server to be protected using the format: http://ip_address/.

2Click Configuration.

3Under Other Settings, click Network/Ports.

4Click Certificate Management.

To enable and configure 802.1x after installing the required certificates:

1Open a Web browser. In the address bar, type the IP address of the printer or print server to be protected using the format: http://ip_address/.

2Click Configuration.

3Under Other Settings, click Network/Ports.

4Click 802.1x Authentication. If a wireless internal print server is installed in the printer, click Wireless instead.

Creating an administrative password

Creating an administrative password allows a system support person to password-protect printer settings. Once a password is created, it must be entered to access the Configuration and Reports pages of the Embedded Web Server. An administrative password for the Embedded Web Server must be created before Secure mode can be activated.

1Open a Web browser.

2In the address bar, type the network printer or print server IP address, and then press Enter.

3Click Configuration.

4Under Other Settings, click Security.

5Click Create Password.

6Type the same password in each Password box. Changing this setting will cause the print server to reset.

7Click Submit.

Using Secure mode

Secure mode is a way to securely communicate over Transmission Control Protocol (TCP) and User Datagram Protocol (UDP) ports.

Note: An administrative password for the Embedded Web Server must be created before Secure mode can be enabled.

To configure Secure mode using the Embedded Web Server:

1Open a Web browser.

2In the address bar, type the network printer or print server IP address, and then press Enter.

3Click Configuration.

4Under Other Settings, click Security.

146