Lexmark C935 manual Standby Mode, Alarms, Timeouts

Menu item	Description
Standby Mode	Sets the amount of time in minutes the printer waits—in a
Disabled	ready-to-print state, after a job is printed—before passing into
	Power Saver mode
1–240
	Notes:
	•	Disabled is the factory default setting.
	• This setting must be less than or equal to the Power Saver
		mode setting.
Alarms	Sets an alarm to sound when the printer requires operator
Alarm Control	intervention
Toner Alarm	Available selections for each alarm type are:
Staple Alarm		Off
Hole Punch Alarm		Single
		Continuous
	Notes:
	•	Single is the factory default setting for Alarm Control.
		Single sounds three quick beeps.
	•	Off is the factory default setting for Toner Alarm, Staple
		Alarm, and Hole Punch Alarm. Off means no alarm will
		sound.
	•	Continuous repeats three beeps every 10 seconds.
	•	Stapler Alarm and Hole Punch Alarm are available only
		when the finisher is installed.
Timeouts	Sets the amount of time in seconds the printer waits before
Screen Timeout	returning the printer display to a Ready state
15–300	Note: 30 seconds is the factory default setting.
Timeouts	Sets the amount of time in seconds the printer waits to receive
Print Timeout	an end-of-job message before canceling the remainder of the
	print job
Disabled
1–255	Notes:
	•	90 seconds is the factory default setting.
	•	When the timer expires, any partially printed page still in
		the printer is printed, and then the printer checks to see if
		any new print jobs are waiting.
	•	Print Timeout is available only when using PCL or PPDS
		emulation. This setting has no effect on PostScript
		emulation print jobs.
Timeouts	Sets the amount of time in seconds the printer waits for
Wait Timeout	additional data before canceling a print job
Disabled	Notes:
15–65535	•	40 seconds is the factory default setting.
	•	Wait Timeout is available only when the printer is using
		PostScript emulation. This setting has no effect on PCL or
		PPDS emulation print jobs.

82