OPERATION | ||
|
|
|
PROCEDURE/MEMORY PANEL OPERA- TION
(For Code 11313):
The Dual Procedure/Memory Panel performs three functions:
•Weld procedure selection
•Memory save and recall
•Limits setting
There are two procedure memories (A and B) and six user memories
Procedure Memory vs. User Memory
Procedure memory is used while welding. Changes to the weld procedure (WFS, voltage, arc control, etc.) immediately change the contents inside the selected procedure memory.
User memories work by copying the weld procedure from one of the six memories into either the A or B procedure. Weld procedures are saved into the mem- ories only when the operator chooses.
USER
PROCEDUREMEMORIES
MEMORY
USER MEMORIES
Recall a memory with memory buttons
To recall a user a memory, press one of the six user memory buttons. The memory is recalled when the button is released. Do not hold the button for more than two seconds when recalling a user memory.
Recall a memory with the gun trigger
If desired, memories 2 through 6 can be recalled with the gun trigger. For example, to recall memory 3, quickly pull and release the gun trigger 3 times without welding.
Note: the POWER FEED™ Wire Feeders are factory set with this feature disabled. Use the SETUP menu and change P.4 to enable memory recall with the gun trigger.
Save a memory with memory buttons
To save a memory, press and hold the desired memo- ry button for two seconds. When the button is initially pressed, the corresponding LED will illuminate. After two seconds, the LED will turn off. Do not hold the button for more than 5 seconds when saving a user memory.
|
|
| M | MEMORY | M |
PROCEDURE |
|
|
| ||
A | GUN | B | 1 | 2 | 3 |
|
|
| |||
|
|
|
| HOLD 2 SECONDS TO SAVE |
|
|
|
| 4 | 5 | 6 |
Note: that memories may be locked using Weld Manager from a P.C. or Palm application to prevent accidental overwrite of the memories. If an attempt is made to save a memory when memory saving is locked, the message "Memory save is Disabled!" will appear briefly in the MSP4 display.
RECALLSAVE
PRESS 1 PRESS 2
SECOND SECONDS
Using Procedure Memories |
|
|
|
|
|
| M | MEMORY | M |
Procedure memories can be selected by choosing | PROCEDURE |
|
|
|
either "A" or "B" procedure directly with the memory | A GUN B | 1 | 2 | 3 |
| ||||
panel, or by selecting "GUN" and using a dual proce- |
|
|
|
|
dure gun to select between procedure "A" and "B". |
|
| HOLD 2 SECONDS TO SAVE |
|
|
|
|
| |
When selecting procedures with the gun switch, "A" or |
| 4 | 5 | 6 |
"B" will flash to show which procedure is active. |
| |||
|
|
|
|
| M | MEMORY | M |
PROCEDURE |
|
|
|
A GUN B | 1 | 2 | 3 |
| |||
|
| HOLD 2 SECONDS TO SAVE |
|
| 4 | 5 | 6 |
PRESS TO |
|
|
|
SELECT |
|
|
|
PROCEDURE OR |
|
|
|
QUICK TRIGGER- |
|
|
|
WHILE |
|
| POWER FEED™ 25M |
WELDING |
|
|
|
