OPERATION | ||
|
|
|
If the passcode does not equal zero (0000), enter the passcode now. If the passcode has been forgotten, a p.c. computer application or Palm O.S. application is required to change the passcode
Memory Value |
| High Limit |
| Low Limit | |
|
| |
| WAVEFORM CONTROL TECHNOLOGY | |
IR PORT | 200Lo == | 180200 |
| Hi |
|
|
| SETUP |
| Weld WFS | |
WELD MODE |
| START OPTIONS |
ARC CONTROL |
| END OPTIONS |
SET
Parameter Name
If the passcode has been set to zero (0000), SETUP will illuminate on the MSP4 panel and the display will show the following:
Four items show on the MSP4 panel.
•Memory Value
•High Limit
•Low Limit
•Parameter Name
One of these items will flash to indicate which item will change when the MSP4 encoder is rotated. Press the right button on the MSP4 panel to select the item to change.
The Limits Setup menu shows a list of all parameters available for the weld mode stored in the memory cho- sen. For example, if limits are being set for a stick (SMAW) mode, parameters such as
To lock a parameter to a specific value that cannot be changed, set the high and low limits to the same value.
| WAVEFORM CONTROL TECHNOLOGY | |
IR PORT | 200Lo == | 180200 |
| Hi |
|
|
| SETUP |
| Weld WFS | |
WELD MODE |
| START OPTIONS |
ARC CONTROL |
| END OPTIONS |
| SET |
|
| Rotate to | Press to |
| Change | select item |
| Value. | to change. |
The memory value must always be less than or equal to the high limit, and greater than or equal to the low limit.
After setting limits, press the memory button with the flashing LED. The MSP4 will ask to save or discard the limit changes just made. Press the left MSP4 for button (YES) to save and enable the limits and exit. Press the right MSP4 button (NO) to exit and leave limits unchanged.
Enabling/Disabling Limits
Enable/Disable
Limits: Press
10 seconds
MMEMORYM
PROCEDURE
A GUN B
1 2 3
HOLD 2 SECONDS TO SAVE
4 
5 
6 
Limits for each memory may be enabled or disabled by pressing and hold the appropriate memory button for 10 seconds. Release the memory button when the MSP4 display shows the following:
| WAVEFORM CONTROL TECHNOLOGY |
| Memory 1 |
IR PORT | Limits |
| SETUP |
| Enable/Disable |
WELD MODE | START OPTIONS |
ARC CONTROL | END OPTIONS |
| SET |
If the passcode does not equal zero, enter the passcode now. If the passcode is zero (0000), SETUP will light and the MSP4 displays the following:
WAVEFORM CONTROL TECHNOLOGY
| Enable |
IR PORT | Limits? |
| SETUP |
Yes | No |
WELD MODE | START OPTIONS |
ARC CONTROL | END OPTIONS |
| SET |
Press the left MSP4 button (YES) to enable limits or the right MSP4 button (NO) to disable limits. Disabling limits does not change any limits values that may have been previously set.
