
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR
CONTROL BOARD REMOVAL AND REPLACEMENT (continued)
5. Locate the control board and the five molex | 6. Carefully remove the five molex type plugs by |
type plugs connected to it. See Figure F.17. | depressing the locking tabs and gently |
| extracting the plugs from the P.C. board |
| receptacles. |
FIGURE F.18 - CONTROL BOARD REMOVAL FROM MOUNTING PINS
DEPRESS
LOCKING TAB ON
MOUNTING PIN
MOUNTING
PIN (8)
CONTROL
BOARD
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
7.Using the
CAUTION
Be sure to follow the recommended
8.When replacing the control board, align the mounting holes with the eight mounting pins and gently slide the P.C. board onto the mounting pins until the board “snaps” onto the pins.
9.Replace the five molex type plugs in their respective receptacles. Be certain they are securely in place.
10.Carefully reposition the front assembly in place and install the four mounting screws previously removed.
11.Inspect, clear and secure all leads before installing the case
12.Using the 5/16” nut driver, install the case wraparound.