Installing and Configuring the PassageWay
Service Provider
Upgrading the PassageWay Service
Provider or PassageWay Solution
This section applies to users who have an earlier version of the PassageWay Service Provider or PassageWay Solution installed. If you do not have an existing version of the PassageWay Service Provider or PassageWay Solution installed, refer to the previous section, “New PassageWay Service Provider Users.”
If you have an earlier version of the PassageWay Service Provider software or PassageWay Solution installed on your PC, perform the following steps:
1.Read the section “PassageWay Service Provider Components” to make sure that you have all of the PassageWay Service Provider components.
2.Read the section “PassageWay Service Provider Requirements” to make sure that you have the required hardware and software to run the PassageWay Service Provider.
3.Read the section “Before You Begin” to make sure that you have the necessary information to set up the PassageWay Service Provider.
4.Install the PassageWay Service Provider by performing the procedures in the section “Installing the Software.”
