Lucent Technologies 3000, 6000 Encaps=COMB, Password Reqd, Interval, Compression, Encaps=FR and Encaps=FR_CIR

4-24 MAX 6000/3000 Network Configuration Guide
Configuring Individual WAN Connections
The Connection profile
CBCP Mode
CBCP Trunk Group
IPX Header Compression
Split Code.User
Encaps=COMB
When Connections > Connection profile > Encaps=PPP, the following parameters appear in
the interface for Ethernet > Connections > Connection profile > Encaps Options:
Ethernet
Connections
Connection profile
Password Reqd
Send PW
Recv PW
Interval
Base Ch Count
Compression
Password Reqd
Whether a password will be required to authenticate the Combinet connection.
Interval
Number of seconds between the receipt or transmission of Combinet line-integrity packets. If
the MAX unit does not receive a Combinet line-integrity packet within three of these intervals,
it disconnects the call.
Compression
Whether data compression is on or off for a Combinet link. Both sides of the link must enable
compression for the algorithm to have any effect.
Encaps=FR and Encaps=FR_CIR
When Connections > Connection profile > Encaps=FR and when Connections > Connection
profile > Encaps=FR_CIR, the following parameters appear in the interface for Ethernet >
Connections > Connection profile > Encaps Options:
Parameter Specifies
FR Prof Name of the Frame Relay profile to use for forwarding this lin k on the
Frame Relay network.
DLCI Frame Relay Data Link Connection Indicator (DLCI) number for a
gateway or circuit connection. A DLCI is a number between 16 and
991, which is assigned by the Frame Relay administrator. A DLCI is
not an address, but a local label that identifies a logical link between a
device and a Frame Relay switch. The switch uses the DLCI to route
frames through the network, and the DLCI may change as frames are
passed through multiple switches.