Lucent Technologies 3000, 6000 Configuring EU connections

Configuring Individual WAN Connections
Configuring EU connections
MAX 6000/3000 Network Configuration Guide 4-93
Example of Combinet configuration
To configure a Combinet connection:
1Open a Connection profile.
2Specify the MAC address of the remote device as the value for the Station parameter, and
activate the profile. For example:
Ethernet
Connection
000145CFCF01
Station=000145CFCF01
Active=Yes
3Configure bridging options as follows:
Bridge=Yes
Dial Brdcast=Yes
4Select Combinet encapsulation and then configure COMB options for this connection.
(Leave the default values for Compression and Interval.) For example:
Encaps=COMB
Encaps Options
Password Reqd=Yes
Send PW=*SECURE*
Recv PW=*SECURE*
Interval=10
Base Ch Count=2
Compression=Yes
5Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring EU connections
EU encapsulation is a type of X.75 HDLC encapsulation commonly used in European
countries. Like PPP, EU runs over synchronous lines. It h a s no asynchronous mode for
connecting to modems. EU encapsulation differs from a PPP or MP+ connections in that it
does not support password authentication, IP/IPX address pools, or DBA. It does support
routing and bridging connections.
EU-RAW and EU-UI do not provide password authentication of incoming calls, so another
mode of authentication is typically used to verify the caller when the call is end-to-end ISDN.
For details, see the MAX Security Supplement.
EU configuration involves the following parameters (shown with sample settings):
Ethernet
Answer
Id Auth=Called Reqd
Encaps
EU-UI=Yes
EU-RAW=Yes
Ethernet
Connections
Connection profile
Calling #=555-7878