Matrox Electronic Systems II VMChannel interface connector, Top view of board, Side view of board

88 Appendix B: Technical information Matrox Meteor-II /Standard

The mating connector included with the board is a 30-pin male, 0.050 pitch right angle connector. Parts for cables can be purchased from:

■ Manufacturer:	Fujitsu
■ Connector	FCN-217J030-G/O

This connector interfaces with a ribbon cable, 0.025 inch pitch (0.635 mm), AWG #30 (solid wire).

VMChannel interface connector

The VMChannel interface allows Matrox Meteor-II /Standard to share data with any Matrox imaging board that has a VMChannel interface capable of performing the bus controller function. A VMChannel backplane (available with the GEN-BUS/... interconnect kits) must be inserted across the VMChannel interfaces of the boards.

Note the VMChannel is not supported on the CompactPCI and

PC/104-Plusform factors.

pin 34	top view of board		pin 1
		(component side)
pin 68			pin 35

side view of board

pin 68 (component side) pin 35

The following table provides the pinout of the VMChannel interface:

Pin	Signal	Pin	Signal
1	SAN	35	N/C*