Installing Matrox Meteor-II 29
Installing Matrox Meteor-II for PC/104-Plus
Use the following steps to install your Matrox Meteor-II board for PC/104-Plus:
1.Matrox Meteor-II for PC/104-Pluscan operate in either a 5V or 3.3V system. In some cases, a hole in the PC/104-Plus(PCI) connector is filled, which prevents another PC/104-Plusmodule from being stacked on top. To install Matrox Meteor-II for PC/104-Plusin a system with a specific signalling environment, a pin must be removed. The table and diagram below indicate which pins to cut, and their locations on the connector.
Signalling | Pin to remove |
environment | on J3 connector |
| |
| |
5V | A1 |
| |
3.3V | D30 |
| |
Remove pin D30 in a 3.3 V system
PC/104-Plus
(PCI)
PC/104-Plus
expansion site
| Remove pin A1 | Top view |
| in a 5 V system |
| |
2.Connect the Matrox Meteor-II MJPEG module to the board if required. See the section, Installing the Matrox Meteor-II MJPEG module.
