Matrox Electronic Systems II manual PC/104- Plus PCI connector

30Chapter 2: Hardware installation

3.Check that you have an available PC/104-Plusconnector on the motherboard, or verify that your existing stack can support another board.

4.If you have existing PC/104 boards in your computer, remove them and stack them on the PC/104-Plusboard. PC/104 boards must be stacked last.

5.Remove the anchoring screws from the stack; do not discard them since you will need them to fasten the Matrox Meteor-II board.

6.Carefully position Matrox Meteor-II over the connectors and press the board firmly into place.

7.Replace the anchoring screws.

8.Set the rotary switch (next to the PC/104 (ISA) connector) to 0 if installing the first stackable module, or another appropriate setting if not the first. See the section, Multiple board installation, in Chapter 4.

PC/104-Plus		PC/104
(PCI) connector
		(ISA)connector
	Expansion
	module
	connectors
		Rotary
		switch

Video input

Motherboardconnector

9.Connect your video sources. For details, see the Connecting external devices section.