26Chapter 2: Hardware installation
■If present, remove the blank metal plate located at the back of a slot next to the Matrox Meteor-II /Digital board; do not discard this screw.
■Install the bracket with the trigger and RS-232 input connectors and fasten it with the screw you just removed.
■Connect the cables to the 4-pin trigger connector and the 10-pin RS-232 connector on the Matrox Meteor-II /Digital board (see figure below).
9.Replace the cover of your computer.
10.Connect your video sources. For details, see the Connecting external devices section.
11.Turn on your computer.
Under Windows 98, when you boot your computer, Windows’ Plug-and-Play system will detect a new PCI card and you will be asked to assign a driver to it. At this point, you should click on Cancel because the driver will be installed during the installation of MIL or one of its derivatives.
