Motorola 3460 manual Verify Password, DCD Control

		3460 Fast’R
AT Command Set (continued)
Command	Option	Description
*ZV		Verify Password
		If access security is enabled, this option selects the
		method used to verify a password.
	0	=Disable. Password and callback are disabled.
	1	=Internal.The stored password is checked against the
		received password. See AT*ZI (Enter Group PW?).
		& Commands
&C		DCD Control
		Determines how the modem signals computer with DCD
		on EIA/TIA 232-D Pin 8 (V.24 Circuit 109).
	0	=High. DCD is always asserted.
	1	=Normal. DCD is deasserted during dialing and while
		the modem is training with the remote modem. DCD is
		asserted in data mode. It is deasserted when the modem
		is disconnected from the telephone line.
	2	=ACU On. DCD is asserted when the modem is
		disconnected so that terminals requiring this signal can
		use the ACU. During dialing, DCD is deasserted until
		both modems train and are ready to pass data. DCD is
		asserted in data mode. DCD is deasserted momentarily
		on a disconnect.
	3	=Remote. Applies to simulated half-duplex applications;
		works only if the remote modem also supports RTS/
		DCD signaling. When the remote computer asserts RTS,
		DCD is asserted at the local modem. The local modem
		can receive data only during this period. Once the
		remote computer deasserts RTS, DCD is de-asserted at
		the local modem. The Rem RTS/DCD option lets you
		specify the RTS/DCD signaling.
	4	=Wink. DCD is always asserted; however, it is
		deasserted after disconnect and remains so momentarily
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.

B-23