Motorola 3460 manual AT Commands for Modem Tasks, AT Commands to Manage Option Sets Enter This

3460 Fast’R

Table 3-1. Option-Set Default Options (continued)

	Pre-Configured Default Option
	Option Set 1	Option Set 2
Command	(Asynchronous)	(Synchronous)
Sync Idle	AT*V11=Char1	AT*V11=Char1
V.25 Response	AT*VR1=V.25bis1	AT*VR1=V.25bis1

Parameters and options shown shaded gray vary by country. For details, refer to Appendix B of the 3460 Fast’R Reference Guide .

1Parameter option does not affect normal operation.

AT Commands for Modem Tasks

Table 3-2. AT Commands to Manage Option Sets

	Enter This
To...	Command:
Load Option Set 1 into modem memory	ATZ0 or ATZ1
Load Option Set 2 into modem memory	ATZ2
Specify that the modem loads Option Set 1 into	AT&Y1
memory at subsequent power-ups
Specify that the modem loads Option Set 2 into	AT&Y2
memory at subsequent power-ups
Specify that the modem loads the last-saved option	AT&Y0
set (AT&W) at subsequent power-ups
Save the active configuration into Option Set 1	AT&W0 or AT&W1
Save the active configuration into Option Set 2	AT&W2

AT Action Commands

AT commands for performing basic functions are as follows.

Table 3-3. AT “Action” Commands

Command & Option	Description
+++	Enter Local Escape Mode
#####	Enter Remote Escape Mode
A/	Re-Execute Last Command

*The contents of the following S-registers are not automatically saved when power is removed: 0, 1, 2, 3, 4, 5, 41, 42. To retain values, save them to an option set. (S-Registers are storage areas for some parameter options.)

3-8