Motorola 3460 manual Hold Dial Line, Dial to Leased Threshold

		3460 Fast’R
AT Command Set (continued)
Command	Option	Description
	3	=RTS/CTS. In asynchronous applications, the local
		modem and computer use RTS/CTS signals to operate
		flow control. The terminal uses RTS to signal when its
		buffers are full. The modem uses CTS to signal when its
		buffers are full. An on-to-off transition signals the
		transmitting device to stop sending data; an off-to-on
		transition signals that data can flow.
	4	=XOn/XOff PT. XON/XOFF Pass-Through Flow
		Control. The local modem and computer operate flow
		control by passing characters embedded in the data
		stream between them. Check your computer manual to
		verify whether it recognizes XON/XOFF flow control.
*HD		Hold Dial Line
		The originating modem uses the HD option to determine
		how long to hold a dial connection while testing a leased
		line.
		This parameter works only when the Initiate/Terminate
		Restoral parameter (*RE) is set to NM/Fast’RVu/Auto
		(option 4).
	0	=Off. Modem disconnects from the dial line as soon as it
		connects to the leased line.
	1	=1 minutes
	2	=2 minutes
	3	=3 minutes
	4	=4 minutes
	5	=5 minutes
*LE		Dial to Leased Threshold
		Determines when the originating modem disconnects
		from a dial line and returns to leased-line operation.
	0	=Off
	1	=15 minutes
	2	=30 minutes
	3	=1 hour
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.

B-10