Motorola 3460 manual Automatically Redial Failed Calls, Transmit Level for Dialed Calls

		3460 Fast’R
AT Command Set (continued)
Command	Option	Description
*DR		Automatically Redial Failed Calls
		The modem waits for a country-specific time between
		redials. If the AT*LN option is enabled, the modem
		dials all of the linked numbers before redialing.
	0	=Disable.
	n	n=0 to 15. Modem redials an unsuccessful call n times.
*DX		Transmit Level for Dialed Calls
	n	n=0 to 20 (negative sign is assumed) dB
*EC		Error Correction Protocol
	0	=V.42. The modems negotiate the use of LAPM or MNP
		error correction. The modems attempt to negotiate using
		LAPM. If unsuccessful, they attempt to negotiate using
		MNP.
	1	=LAP-M. The modems attempt to negotiate LAPM.
	2	=MNP. The modems attempt to negotiate MNP.
*FL		Flow Control Protocol
		Allows the modems and computers in a link to control
		the flow of data when buffers near their capacity. Use
		some type of flow control when operating in the Normal
		or Reliable mode. Check the computer documentation to
		ensure that it supports the flow control you select.
		The +FL command also controls this value.
	0	=Disable
	1	=XOn/XOff. The local modem and computer operate
		flow control by passing characters embedded in the data
		stream between them. The XOFF character signals the
		transmitting device to stop sending data. The XON
		character lets the halted device start sending data.
	2	=DTR/CTS. In asynchronous applications, the local
		modem and computer use DTR/CTS signals to operate
		flow control.
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.

B-9