Motorola 3460 manual Network Control NC Address, Buffer Option, Display Stored Telephone Number

		3460 Fast’R
AT Command Set (continued)
Command	Option	Description
	9	=14.4 KBPS
	10	=16.8 KBPS
	11	=19.2 KBPS
	12	=21.6 KBPS
	13	=24.0 KBPS
	14	=26.4 KBPS
	15	=28.8 KBPS
	16	=31.2 KBPS
	17	=33.6 KBPS
*NA		Network Control (NC) Address
		Specifies a modem’s network-management identifier.
		Note: if this command is issued while the modem is
		attached to a network-management system, the modem
		responds “NETWORK MANAGEMENT INHIBITED”
		and does not change its address.
	0	Default. Not a valid operating address.
	1-255	Available options
*NB		Buffer Option
		Specifies the size buffers that store data received from a
		local computer. Use this parameter if computer-to-
		computer flow control is enabled, to reduce the amount
		of data sent to the remote computer when a flow-off
		condition is received at the local computer.
	0	=Regular. Normal capacity buffers.
	1	=Reduced. Reduced sized buffers, allowing less data to
		accumulate in the modem.
*ND		Display Stored Telephone Number
	n	Telephone Number n, where n is 1-4.
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.

B-14