3460 Fast’R

 

 

Installing a Stand-Alone Modem (continued)

 

 

 

Step

 

Action

 

 

4.

If ferrite beads are included with your modem, install them on

 

both telephone cables:

 

a)

Snugly wrap the cable once completely around the

 

 

bead (Figure 1-2).

 

b)

Set the cable into the bead cutouts. Ensure that 2.5 to

 

 

4 cm of the cable extend from the bead (on the end you

 

 

insert into the modem connector).

 

c)

Snap the bead closed. You can reopen and close it to

 

 

reset the cable.

 

 

5.

For two-wire leased-line or dial-line modems:

 

a)

Plug the telephone cable into the modem’s LINE

 

 

connector (Figure 1-3) and to the telephone wall jack.

 

b)

To use a telephone set on the same line as the modem,

 

 

ensure that the ferrite bead (if included) is installed on

 

 

the cable; then plug it into the modem’s PHONE

 

 

connector.

 

For two- or four-wire leased-line/dial-line modems:

 

a)

Optionally, plug an analog dial line telephone cable

 

 

into the modem’s PHONE LINE connector

 

 

(Figure 1-3) and to the telephone wall jack.

 

b)

Ensure that the ferrite bead (if included) is installed on

 

 

a leased-line cable; then plug it into the modem’s

 

 

LEASE connector.

 

 

6.

Set the modem power switch to the On (1) position. The modem

 

executes self-tests. A modem indicates test results as follows:

 

Successful completion: MR LED steady on.

 

A problem by setting LEDs in one of these ways:

 

— MR: slowly blinking. TR: on. OH: off. CD: off.

 

— MR: off. TR: on. OH: on. CD: on.

 

You can also check self-test completion with Fast’RVu. Select

 

Status, then select:

 

EIA to display DCD, DTR, DSR, CTS, and RTS signal states

 

Device to display rate and mode parameters that describe the

 

modem’s current state

 

Note the LED pattern. Report any problem to Motorola Support.

 

 

7.

Stand-alone modem hardware installation is complete.

 

Go on to Chapter 2, Basic Modem Setup, or Chapter 3,

 

Advanced Modem Setup.

 

 

 

1-4

Page 18
Image 18
Motorola 3460 manual For two-wire leased-line or dial-line modems, For two- or four-wire leased-line/dial-line modems