Motorola 3460 manual Cabling One or More Enclosures to a Computer, NMS or Fast’RVu

3460 Fast’R

Upper (A) Telephone	Modem Required in This
Connectors, Slots 1-16
	Slot for Management by
	NMS or Fast’RVu

IN	OUT
Computer
Connectors

Power Cord

Lower (B) Telephone

Connectors, Slots 1-16

Rear View, AccessWay Enclosure (Shown With Dual-Modem Cards, Individual RJ-11 Connectors, and AC Power)

Figure 1-8. Cabling an AccessWay Enclosure

Cabling One or More Enclosures to a Computer

You can connect up to four enclosures together and use Fast’RVu to manage all the modems.

Cabling Enclosures Together for Fast’RVu

Step Action

1.Ensure that enclosures are securely installed in equipment racks.

2.Assign addresses to enclosures by setting the DIP switch on each enclosure rear panel. Refer to Table 1-3.

3.Cable the enclosures’ NM OUT (or NC OUT) and NM IN (NC IN) connectors together (Figure 1-9).

4.Cable a computer’s serial communications (COM) port to the first enclosure’s NM IN connector.

5.Refer to Chapter 4 for instructions on using Fast’RVu.

1-18