Motorola 3460 manual Dial Wait Period Pause After Dialing, DTE Computer Port Rate

		3460 Fast’R
AT Command Set (continued)
Command	Option	Description
	1	=Enable. Data compression is attempted.
		If the modem is using LAPM error correction, it uses
		V.42bis data compression when DC=Enabled. Note: In
		an application with SDC enabled, LAPM error
		correction and V.42bis data compression only are used.
		With MNP error correction, the modem attempts to
		negotiate V.42bis and MNP-5 data compression with the
		remote modem.
		Depending on which data compression type the remote
		modem can accommodate, V.42bis or MNP-5 is used.
		Otherwise, no data compression is used.
*DD		Dial Wait Period (Pause After Dialing)
	0	The modem waits 2 seconds for a dial tone.
	1	The modem waits 3 seconds for a dial tone.
	2	The modem waits 4 seconds for a dial tone.
	3	The modem waits 6 seconds for a dial tone.
	4	The modem waits 12 seconds for a dial tone.
	5	The modem waits 15 seconds for a dial tone.
	6	The modem waits 20 seconds for a dial tone.
	7	The modem waits 30 seconds for a dial tone.
	8	The modem waits 40 seconds for a dial tone.
	9	Dial wait is determined by setting S-Register 7.
*DE		DTE (Computer) Port Rate
	0	=75 BPS
	1	=150 BPS
	2	=300 BPS
	3	=600 BPS
	4	=1.2 KBPS
	5	=2.4 KBPS
	6	=4.8 KBPS
	7	=7.2 KBPS
The characters AT or at precede all commands except: +++, #####, and A/
Parameters and options shown shaded gray vary by country. For your country’s options,
refer to the 3460 Fast’R Reference Guide (T0022).
Default (pre-set) options are underlined.

B-7