
Installing the MVME240x Hardware | 1 |
|
2064 9708
Figure 1-3. Typical Single-width PMC Module Placement on MVME240x
5.Slide the edge connector(s) of the PMC module into the front panel opening(s) from behind and place the PMC module on top of the MVME240x. The four connectors on the underside of the PMC module should then connect smoothly with the corresponding connectors for a
6.Insert the two short Phillips screws through the holes at the forward corners of the PMC module, into the standoffs on the MVME240x. Tighten the screws.
7.If installing two
http://www.mcg.mot.com/literature |