![](/images/new-backgrounds/1179726/17972639x1.webp)
1 |
Preparing and Installing the
The MVME240x board supports both front panel I/O and rear panel P2 I/O through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and 46 pins of I/O from slot 2 are routed directly to P2.
VMEsystem Enclosure
Your MVME240x board must be installed in a VMEsystem chassis with both P1 and P2 backplane connections. It requires a single slot, except when PMCspan carrier boards are used. Allow one extra slot for each PMCspan.
System Console Terminal
In normal operation, connection of a debug console terminal is required only if you intend to use the MVME240x’s debug firmware, PPCBug, interactively. An RJ45 connector is provided on the front panel of the MVME240x for this purpose.
Overview of Start-Up Procedures
The following table lists the things you will need to do before you can use this board, and tells where to find the information you need to perform each step. Be sure to read this entire chapter and read all Caution and Warning notes before beginning.
Table 1-3. Start-Up Overview
What you need to do ... | Refer to ... | On page ... | |
|
|
| |
Unpack the hardware. | Unpacking the MVME240x Hardware | ||
|
|
| |
Set jumpers on the MVME240x | Preparing the MVME240x Hardware | ||
module. |
|
| |
MVME240x | |||
| |||
|
|
| |
Prepare the PMCs. | PMCs | ||
|
|
| |
| For additional information on PMCs, refer to |
| |
| the PMC manuals provided with these cards. |
| |
|
|
|
Computer Group Literature Center Web Site |