Installing the MVME240x Hardware | 1 |
|
MVME240x
!
Caution
!
Warning
Before installing the MVME240x into your VME chassis, ensure that the jumpers on the MVME240x J8, J9, and S3 switch are configured, as previously described. This procedure assumes that you have already installed the PMCspan(s) if desired, and any PMCs that you have selected.
Proceed as follows to install the MVME240x in the VME chassis:
1.Attach an ESD strap to your wrist. Attach the other end of the ESD strap to the chassis as a ground. The ESD strap must be secured to your wrist and to ground throughout the procedure.
2.Perform an operating system shutdown:
a.Turn the AC or DC power off and remove the AC cord or DC power lines from the system.
Inserting or removing modules with power applied may result in damage to module components.
Dangerous voltages, capable of causing death, are present in this equipment. Use extreme caution when handling, testing, and adjusting.
b.Remove chassis or system cover(s) as necessary for access to the VMEmodules.
3.Remove the filler panel from the card slot where you are going to install the MVME240x. If you have installed one or more PMCspan PCI expansion modules onto your MVME240x, you will need to remove filler panels from one additional card slot for each PMCspan, above the card slot for the MVME240x.
http://www.mcg.mot.com/literature |
